How it works

What Is Rotational Moulding?

Rotational moulding, or rotomoulding, makes hollow plastic products in one seamless piece. Plastic powder is placed in a mould, and the mould is heated while turning on two axes so that the melted plastic coats its inside evenly.

The four steps

  1. 1. Load. A measured weight of plastic powder, usually polyethylene, goes into a hollow metal mould.
  2. 2. Heat and rotate. The closed mould turns slowly on two axes inside an oven. The powder melts and coats the inside evenly.
  3. 3. Cool. The mould keeps turning while it cools, so the plastic sets with an even wall and holds its shape.
  4. 4. Remove. The finished hollow product comes out of the mould in one piece, ready for fittings.

Why water tanks are made this way

A tank must hold weight and pressure for years, and joins are where containers tend to fail. Rotomoulding makes the whole body as a single piece, with no welded seams along the wall.

The plastic spreads across the mould as it melts, which gives a relatively even wall thickness, including at corners. Large hollow shapes are also practical, because the process needs little pressure and the tooling is simpler than for injection moulding.

What a double-layer tank is

A double-layer tank has two distinct layers in its wall. OGA PLASTIC tanks pair a white inner layer, which makes the water level and cleanliness easier to see, with a UV-stabilised outer layer that faces the sun.

Related